Honeywell PRO4000 Series - Display Screen Information; System Status Indicators; Setting Time and Day; Setting the Clock

2
Set the time and day
Set
Clock
AM
6
:
30
Wed
Set Day
1. Press the SET button, then press
s or t to set the clock time.
2. Press the SET button, then press
s or t to select the day of the
week.
3. Press RUN to save & exit.
NOTE: If the display flashes Set Clock,
the thermostat will follow your settings
for the weekday “Wake” time period
until you reset the time and day.
Current program
period
Wake/Leave/
Return/Sleep
Current day/time
Wake
Wed
Recovery
Em Aux
Heat On
Set To
Inside
AM
75
75
6
:
30
Replace Batt
Current inside
temperature
If flashing, compressor
protection is engaged.
Adaptive Intelligent
Recovery
TM
System Status
Cool On: Cooling system is on.
Heat On: Heating system is on.
Em: Emergency heat is on. **
Aux: Auxiliary heat is on. **
** Only for heat pumps with
this capability (select models
only).
Temperature setting
(or Desired Temperature
when changing temperature)
Low battery
warning
Display screen