EasyManuals Logo

Honeywell RP4D Instructions

Honeywell RP4D
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
About the Battery
Battery Recommendations
Batteries are shipped approximately 30% charged or less and
should be fully charged for maximum charge capacity.
The battery is a lithium ion cell and can be used without a full
charge, and can also be charged without fully discharging
without impacting the battery life. There is no need to perform
any charge/discharge conditioning on this type of battery.
Do not disassemble the battery. There are no user-serviceable
parts in the battery.
Do not allow metallic conductive objects to contact battery
terminals. Do not short-circuit a battery or throw it into a fire;
it can explode and cause severe personal injury.
Improper battery use may result in a fire, explosion, or other
hazard.
Although your battery can be recharged many times, it will
eventually be depleted. Replace it after the battery is unable to
hold an adequate charge.
If you are not sure if the battery or charger is working properly,
send it to Honeywell International Inc. or an authorized service
center for inspection. Refer to Technical Assistance for
additional information.
Use only Honeywell Li-ion battery packs 50133975-
001 or 550053-000 in this device. Use of any non-
Honeywell battery may result in damage not covered
by the warranty.

Other manuals for Honeywell RP4D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell RP4D and is the answer not in the manual?

Honeywell RP4D Specifications

General IconGeneral
BrandHoneywell
ModelRP4D
CategoryPrinter
LanguageEnglish

Related product manuals