Honeywell RT10A - Decode Settings

RT10A Rugged Tablet 31
Decode Settings
Setting Description Default
Center Decode When enabled, the imager scans and decodes a barcode only if
part of the barcode is at the center of the aimer window. This is
useful in situations where several barcodes may be very close
together in the imager field-of-view.
• Tap the check box to toggle the feature On or Off.
•Select Center Decode to adjust the Window dimensions.
Honeywell recommends leaving the settings at 50 (default) to
define the “center” area for the barcode.
Configurable parameters:
•Window top
•Window bottom
•Window left
• Window Right
Disabled
Decode Security Use this setting to control the reading tolerance of the decoder.
Lower settings are more lenient when reading low quality barcodes
while higher values are more strict.
2
Decoder timeout Use this setting to specify the number of milliseconds the decoder
will attempt to process an image before moving on to another.
150
Decode Filter Use this setting to modify or reject data strings.
• Decode Filter Script
Defines the string of text from the filter script. The script is
included in the DataCollectionService.xml settings file.
•Debug Level
Set the filter information level. The default level is 0, no
information. Higher levels emit more information. Level 4
emits the most information
None
Poor Quality 1D
Reading
Enable this setting when scanning damaged or badly printed 1-D
barcodes to improve barcode read success.
Disabled
Video Mode Use this setting to specify whether normal or inverse decoding for
linear symbologies is enabled during the execution of Decode. By
default normal video is enabled.
Options include:
•Normal
•Inverse
•Normal and Inverse
Normal
DPM mode Use this setting when scanning Direct Part Marking (DPM)
barcodes that are etched or imprinted directly into the surfaces of
materials including metal and plastic.
Options include:
• No DPM optimization
• Dot Peen DPM decoding
• Reflective DPM decoding
No DPM
optimi-
zation