RT10A Rugged Tablet 59
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Scanner Edge .
3. Tap the menu icon and then tap Pair BT Scanner.
4. For Honeywell branded scanners tap Honeywell or for Intermec branded
scanners tap Intermec.
5. Scan the Connect Barcode displayed on screen.
6. When the scanner is successfully paired with the computer, the scanner name
appears under Connected Device.
Unpair a Paired Scanner
You can unpair the scanner to remove it from the Connected Device list.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Scanner Edge .
3. Tap the menu icon and then tap Disconnect BT Scanner.
4. Tap Honeywell or Intermec.
5. Scan the Disconnect Barcode displayed on screen.
About Serial and USB Communications
You can use these optional RT10A accessories to transmit data to and receive data
from another device through serial or USB communications:
•Vehicle dock
•Home Base
• Ethernet Home Base
For information about these accessories, contact your local sales representative.
USB Troubleshooting
• If you have a problem with your workstation computer recognizing the USB
device, try downloading and installing the Honeywell-aidc-usb-driver. The
driver is part of the Honeywell_Mobility SDK_Android software.zip file. To learn
where to get the software, see Developer Information on page 60.
• Check to make sure you have enabled the USB for file transfer. To learn more, see
Configure USB Connection and Transfer Files on page 16
To Next Page
Loading...
