RT10A Rugged Tablet 61
About Provisioning Mode
Once you complete the out-of-box initial setup process, Provisioning mode is
automatically turned Off to improve device security against unwanted
modifications to the system.
When Provisioning mode is turned Off (disabled):
• Configuration barcodes do not scan and process.
• \honeywell\autoinstall folders are inaccessible.
Note: To learn more about network and security for Honeywell mobile computers with
Android operating systems, go to www.honeywellaidc.com.
Enable or Disable Provisioning Mode
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Honeywell Settings > Provisioning mode.
3. Tap the button to toggle the provisioning On or Off.
About Wi-Fi Staging
Overview
You can use the Honeywell Wi-Fi Staging app to quickly set up new devices by
configuring one device and using it to stage others. Wi-Fi Staging can also be used
to enroll devices in an Mobile Device Management (MDM) system by connecting
units to a specified network and downloading and installing the specified MDM
client app.
Once you have set up a configuration in the Wi-Fi Staging app on the server device,
Wi-Fi staging will use that device as a hotspot and wait for a client to connect to it.
The configuration will be distributed to the client device once communication is
established between the client and the server device.
Staging Devices
Wi-Fi Staging requires two steps:
1. Setting up a master device to act as a server (see next section).
2. Setting up the client device (see Set Up Client Devices on page 64).
To Next Page
Loading...
