Programmable Thermostat RTH2410
7
Heat Pump Systems with Auxiliary/Backup Heat
(Typical Wiring)
1) Match each labeled wire with the terminal having
the same letter.
2) Loosen the terminal screws using a screwdriver,
insert the wires, then tighten the screws.
3) Push any excess wire back into the wall opening.
r
Connect Wires (cont’d)
7.
Labels don’t match? See page 8.
69-2382ES-01 (RTH2410 5-1-1 QIG) ENG USA.fm Page 7 Monday, October 19, 2009 3:59 PM
To Next Page
Loading...
