Operating Manual
20
Heating or
cooling system
does not respond
• Press
SSYYSSTTEEMM
to set system to Heat. Make sure the temperature is set
higher than the Inside temperature.
• Press
SSYYSSTTEEMM
to set system to Cool. Make sure the temperature is set
lower than the Inside temperature.
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
• If “Wait” is displayed, the compressor protection timer is on. Wait 5
minutes for the system to restart safely, without damaging the
compressor (see page 15).
In case of difficulty
To Next Page
Loading...
