Honeywell SIXFLOODA - User Manual

How to Replace Batteries in a Honeywell Flood Sensor Model
SIXFLOODA
Description
This page shows battery replacement for Honeywell Flood Sensor Model SIXFLOODA
Because there are many different versions of flood sensors, it is important to remove the sensor
cover first to determine what kind of batteries are required for your equipment. We advise you
to check before purchasing batteries.
Preparation
***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the
panel on test mode through myadt.ca. After logging in:
1. Tap [Home]
2. Tap [Place on Test]
3. Enter your expiration date and time
4. Enter your password
5. Tap [Yes-Proceed]
Parts Required
 One CR123A 3-volt lithium battery

Honeywell SIXFLOODA Specifications

General

Sensor Type	Flood Sensor
Wireless	Yes
Power Source	Battery
Battery Life	Up to 5 years
Operating Temperature	32°F to 120°F (0°C to 49°C)
Compatibility	Honeywell Lyric Controller
Type	Flood Detector
Battery Type	CR123A Lithium Battery

Summary

Sensor Description and Battery Check

Description of Honeywell Flood Sensor

Details the Honeywell Flood Sensor Model SIXFLOODA and the importance of checking sensor cover for correct battery type.

Preparation for Battery Replacement

myADT.ca Preparation Steps

Instructions for placing the panel on test mode via myADT.ca before removing the sensor.

Required Parts for Replacement

Specifies the necessary part for battery replacement: one CR123A 3-volt lithium battery.

Battery Replacement Instructions

Step-by-Step Sensor Battery Change

Detailed steps on how to open the sensor, remove the old battery, insert the new one, and close the cover securely.

Troubleshooting Low Battery Alert

Guidance on re-performing steps if the low battery alert or sensor tamper alert persists after replacement.