EC AP MKT
Page 15
Confidential and Proprietary
Configuration & Operation
Item
Operation Display
F2 Setting
(Temperature
Limit)
• Press “SELECT” to choose “F2”.
• Press key S one time, the setting temperature will be 1
0
C up. Press and hold the key more than 2
seconds, the temperature increases continuously until reaches 60
0
C(internal sensor) or 110
0
C(remote
sensor). Press the button one more time to stop the temperature change.
• Press the key T one time, setting temperature will be1
0
C down. Press it and hold more than 2 seconds,
the temperature decreases continuously until reaches 10
0
C(internal sensor) or -20
0
C(remote sensor).
Press the button one more time, the temperate change stops.
• Press “ENTER” to save the setting value
Output2
Description
If output2 has no output signal, the screen shows “DO OPEN” and the resistance value is high. Otherwise the
screen shows “DO CLOSE” and the resistance value is low.
To Next Page
Loading...
