T775A/B/M SERIES 2000 CONTROLLER 3. SCHEDULING
62-0254–03 30
3. SCHEDULING
Scheduling provides the ability to set daily temperature
settings for up to two events per day. Typically, these are
the daytime (setpoint) and the nighttime (setback)
settings.
IMPORTANT
To enable Scheduling, you must first enter Setup
mode (press and hold the MENU button for 5
seconds), select OUTPUTS, select OPTIONS,
select USE SCHED, and then select YES. (see
“2.3.3.1. USE SCHED” on page 24).
IMPORTANT
To properly account for Daylight Saving time, be
sure to set the Date before setting the Time.
See “3.2.2. SET DATE” on page 31.
NOTE: Each output is independently configurable to
follow the schedule or not. For modulating
outputs, see “2.3.1.5. SCHEDULE” on page 23.
For relay outputs, see “2.3.4.2. SCHEDULE” on
page 28.
NOTE: The controller interface is intuitive. You may find
that you do not need the following scheduling
instructions. You may want to use this procedure
simply as a reference to locate the particular
option or parameter of interest.
NOTES:
1. If you press the HOME button or there is no
keypad activity for four minutes, you exit
Scheduling mode and return to the home
screen.
2. If you press the MENU button, you exit
Scheduling mode and return to the menu.
To create or change a schedule, you use the —
• Left arrow button (W) to scroll backward through the
Schedule menus
• Right arrow button (X) to select the highlighted menu
item and display its content
• Up and Down arrow buttons (S and T) to scroll up
and down through a list of items or to increase or
decrease the value of a displayed schedule parameter
Creating a Schedule
To create a schedule, perform the following in the order
listed:
1. Enable Scheduling in Setup mode - see “2.3.3.1.
USE SCHED” on page 24
2. Enter Schedule mode — see “3.1. Entering Sched-
ule Mode”
3. Set the Schedule Options — see “3.2. OPTIONS”
4. Set Individual Schedules — begin with “3.3. Setting
Individual Schedules” on page 32
5. Exit Schedule Mode — see “3.4. Exiting Scheduling
Mode” on page 33
Fig. 69. Schedule - Menu.
3.1. Entering Schedule Mode
Press the MENU button, then select SCHEDULE and
press the X button to view the Schedule menu.
Fig. 70. Schedule - Options Menu.
3.2. OPTIONS
1. From the Schedule menu, use the S and T buttons
to highlight OPTIONS.
2. Press the X button to display the Options menu.
MENU
SCHEDULE
MENU
SCHEDULE
OPTIONS
MON-FRI
SAT-SUN
MONDAY
TUESDAY
WEDNESDAY
THURSDAY
FRIDAY
SATURDAY
SUNDAY
EXIT
M24536
MENU
SCHEDULE
OPTIONS
MENU
SCHEDULE
OPTIONS
SET TIME
SET DATE
DAYLIGHT
EXIT
M24537
To Next Page
Loading...
