Operating Manual
10
ENGLISH
n
Press the
Set
button 3 times until
Set Schedule
appears. The start time of
the first period (Wake) of the week days (Mon-Fri) will flash.
o Press the or button to set the time.
p Press the Set button. The temperature setting for that period will flash.
q To program the temperature settings for the cooling mode, place the
System switch in Cool. To program the temperature settings for the
heating mode, place the switch in Heat.
r Press the or button to set the temperature.
s Press the Set button. The start time of the next period will flash.
t Repeat steps 2 through 6 for each of the remaining periods.
u Once all adjustments are made, press the Run button to save them and
exit. (The changes are also saved if you do not press any button for 60 seconds.)
Modifying the schedule
The Wake
period for the
weekdays is
set to 6 a.m.
and 70 °F
(Heating
mode).
To skip a
period (except
Wake), press
the Hold
button for 4
sec. while that
period is
displayed.
400-626-001-C (69-1969EFS-03 prog TH2110D_TH2210D user manual) USA.book Page 10 Tuesday, September 8, 2009 10:05 AM
To Next Page
Loading...
Need help?
General
