Honeywell THP9045A - Step 5 Connect the Wire Saver

7
Step 5 Connect the wire saver
Connecting the wire saver involves two main actions: moving some wire connections
from the terminal block in your heating/cooling system to the THERMOSTAT terminal block
of the wire saver and using the included wire bundle to connect the terminal block on the
equipment to the EQUIPMENT block on the wire saver.
To connect the wire saver, follow the instructions and diagram for your setup as
determined in Step 4.
• Follow instructions under 5a if you have a single stage setup.
.
• Follow instructions under 5b if you have two-stage heat, single-stage cooling.
• Follow instructions under 5c if you have two-stage heating and cooling.