Honeywell VisionPRO IAQ - System setting

VisionPRO
®
IAQ
9
1
2
3
4
5
6
7
Cooling system
Fan system
Heating system
Emergency
heating system
Humidifier
Dehumidifier
Ventilator
Installer system test (English: Page 4 • Français: Page 10 • Español: Página 16)
System test System status
During installer setup, press ▼
repeatedly until “Test” appears
DONE
0120 20
DONE
TEST 0
1
Test
number
System
status
Press ▲▼ to
select test
Press ▲▼ to
change status
Press DONE to terminate testing
CAUTION: EQUIPMENT DAMAGE HAZARD. Compressor protection is bypassed
during testing. To prevent equipment damage, avoid cycling the compressor quickly.
0Off
1 Test cooling stage 1
2 Test cooling stages 1 & 2
0 Fan off
1 Fan on
0Off
1 Test heating stage 1
2 Test heating stages 1, 2
3 Test heating stages 1, 2, 3
4 Test heating stages 1, 2, 3, 4
0Off
1 Test EmHeat stage 1
2 Test EmHeat stages 1, 2
0Off
1On
0Off
1On
0Off
1On
Other messages
P
F
Err
Ventilation meets ASHRAE 62.2 standard (Function 0404)
Ventilation does not meet ASHRAE 62.2 standard (Function 0404)
See error codes (page 22)