Honeywell VisionPRO IAQ - Fan setting

Operating Manual
69-1815EFS—08 6
Press FAN to select fan operation, then press
DONE:
W On: Fan is always on.
W Auto: Fan runs only when the heating or
cooling system is on.
W Circ: Fan runs randomly, about 35% of the
time, not counting any run time with the
heating or cooling system.
You can press FAN to override the fan settings
you’ve programmed for different time periods
©7))4%+)ºª¯*=397)0)'8On or Circ, the
setting you select will remain active until you
press FAN again to select Auto, and return
838,)*%27',)(90)©7))4%+)³¹*36136)
-2*361%8-32ª¯
Note: If a fan schedule is programmed,
“Auto” will run the fan schedule.
Press FAN
SCHED HOLD CLOCK SCREEN MORE
WED
AM
SYSTEM
HEAT
Following
Schedule
Inside
Set To
70
6:01
70
FAN
AUTO
Fan setting