Honeywell VNT5150H1000 - Page 18

ERV/HRVVentilationSystems69-2480EF—01
16
InstallationSteps(continued)
5
Installing the condensation drain line
Insertthethreadeddrainadapterthroughthebottomof
theunitandhandtightentheplasticnutsuppliedwith
thedrainkit.
Useawrenchtotightenthenutanotherhalfturnto
ensureacompleteseal.
Installthecondensatetubingbypushingtheclear
plastictubingoverthedrainadapter.
Makeacondensatetrapbyloopingtheclearplastic
tubing.Thisloopwillpreventfoulodorsfromentering
theunit.
Useacondensatepumpifyoudon’thaveaccessto
thefloordrain.
Drainless Application
NOTE:IfinstallinganERVunit(VNT5150E1000orVNT5200E1000)inaregionwheretheoutdoor
temperaturedoesnotdropbelowfreezing,thecondensatedrainlinedoesnotneedtobe
installedandtheunitmaybeinstalledasadrainlessapplication.
1.Insertthethreadeddrainadapterthroughthebottom
 oftheERVwiththedrainconnectioninsideoftheunit
 asshowninthegure.
2.Fittherubberwasheroverthedrainadapterandthen
 attachtheplasticnut.
3.Handtightentheplasticnutsuppliedwiththedrainkit.
4.Useawrenchtotightenthenutanotherhalfturnto
 ensureacompleteseal.
5.Attachthedraincaptothedrainadapterinsidethe
 unit.