43-TV-33-76 iss.2 GLO Jan 21 UK 11
Re-building the recorder
Rebuilding the recorder is the reverse process.
Feed the backlight leads through the holes in the moulding, and re-connect to the inverter. Pull any loose cable through
the holes.
Before refitting the bezel/touch screen assembly clean any dirt or marks form the back of the touch screen or display.
Use a lint free cloth to clean both parts, do not use any solvents.
Take the display assembly and place it back into the bezel/touch screen assembly. Fit the 4 self tap screws that attach
the two parts.
Offer up the front surround to the unit, reconnect the display lead, pulling up the top of the connector to allow the lead to
be seated, and then push the top down to clamp the lead in place. Re-connect the inverter lead, touch screen lead and
speaker lead.
Slide the front surround assembly onto the chassis plates and fit the 4 self tap screws that hold the unit together.
Slide the case back onto the recorder ensuring it is fitted the right way round. The cooling slots should be at the top of
the unit.
Finally fit the four M3 screws that hold the case to the chassis.
Copyrighted Materials. For more information please contact your supplier.
To Previous Page
Loading...
Need help?
General
