Maintenance
Cleaning and changing the filters
WARNING! Ensure the cleaner is not connected to the mains power when
performing any maintenance duties.
The air inlet filter should be replaced at least twice a year or when it appears dirty.
Always operate the cleaner with filters installed to prevent motor damage and
maximise performance.
1. Cleaning and changing the air inlet filter
a. Remove the dust canister from the unit.
b. Remove the dust canister filter to clean or replace.
2. Gently remove the dust canister by pulling in an
upwards direction.
3. Suspend the dust canister in an upright position over a
rubbish bin (or location of disposal). Press the locking button
on low end of dust barrel to open base and allow the dust
to fall from the canister.
4. Close the base of dust canister and insert the canister back
into the cleaner.
NOTE: This cleaner has a handle at the top rear of the body,
you can use it to conveniently carry the appliance.
Carry
Handle
Instructions for Use (continued)
To Next Page
Loading...
