OPERATION
CAUTION: Do not clean over floor electrical outlets. Water will drip from the tool after use and may puddle. To avoid
damage to wood and laminate flooring and to avoid potential slip hazard, after use (a) do not leave the product on
wood and laminate surfaces and move to a hard surface and (b) place unit on an absorbent material (such as a
towel) to soak up drips.
1. Press Red Power Button on top unit to turn ON.
2. Hold tool about 5 inches over the spot or stain. Spray a generous amount of cleaning solution over the soiled
area by pressing the trigger behind the tool and scrub the stain in a back and forth motion.
3. To lift the stain, suction up the dirt and cleaning solution by applying downward pressure on the front of the
cleaning tool and pulling towards you. Repeat as needed.
IMPORTANT: Empty the Recovery Tank when it reaches the MAX fill line or you hear an audible change.
Ensure the tank is secured before cleaning. Ensure the tank is secured before cleaning.
To Next Page
Loading...
Need help?
General
