3. Ensure both the solution and recovery tanks are secured on unit. Turn unit on and hold the trigger for 30
seconds. The clean water will rush through the hose, effectively cleaning and removing odor causing bacteria
left in the hose. Repeat as needed. Let unit run for 5-10 seconds before turning off.
4. Repeat process as needed and turn off the unit when hose is fully clean. Empty the recovery tank.
THERMAL PROTECTION
A thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector
activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Empty Recovery Tank.
3. Inspect for any obstructions.
Clear obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate and cleaning
may continue.
If the thermal protector continues to activate after following the above steps, your cleaner needs servicing.
FORMULA RATIO CHART SMALL AREA (20 OZ) LARGE AREA (40 OZ)
IF USING HOOVER CONCENTRATE
Water Fill water Small Area Line (20 oz) Fill water Large Area Line (39 oz)
HOOVER 2X Concentrated
Formula
0.5 oz 1 oz
Clean Complements Enhancer Up to 1 oz Up to 1 oz
IF USING HOOVER READY-TO-USE PREMIX
Premixed Formula Fill premix Small Area Line Fill premix Large Area Line
Clean Complements Enhancer Up to 1 oz Up to 1 oz
TROUBLESHOOTING
REPLACEMENT PARTS AND ACCESSORIES SUCH AS SOLUTIONS AVAILABLE AT HOOVER.COM.
To Next Page
Loading...
Need help?
General
