PREPARING YOUR CLEANER
BEFORE CLEANING CARPET
• Vacuum carpet thoroughly.
Use a vacuum cleaner with a power
head for best results.
• Test for colourfastness
• Move the furniture
Raise the handle to the upright position
until it locks in place.
- 4 -
1
Remove the accessories from the
following:
Cleaner body
Cloth adaptor plate*
Cloth*
2
Test for colourfastness - Wet a white absorbent
cloth with the solution. In a small, hidden area
of your carpet, gently rub the surface with the
dampened cloth.
Wait ten minutes and check for colour removal or
bleed with a white paper towel.
If your carpet has more than one colour, check
all colours.
When cleaning an entire room, move furniture
out of the area to be cleaned. If the furniture is
too heavy to move, place aluminium foil or wax
paper under legs. This will prevent wood
finishes from staining your carpet. Pin up
furniture skirts and curtains.
NOTE: Do not over saturate your carpet.
To fold the handle press the handle
release button and fold to the storage
position.
4
Once the handle has been lowered lift
the carry handle to allow the cleaner to
be carried from room to room.
3
5
!
IMPORTANT: This cleaner
should not be used to dry
vacuum the carpet.
!
(*Certain models only)
This appliance should be switched off and
disconnected form the power supply before
preparing the cleaner.
To Next Page
Loading...
Need help?
General
