FILLING THE CLEAN WATER TANK
Press the clean water tank release latch
and remove from the cleaner.
Mix the solution with warm water.
(Max. temperature - 40ºC)
Add the required amount of cleaning
(approx. 40ml per 1L of water)
- 5 -
1
Pour the solution into the clean water
Replace the cap and return the clean
water tank to the cleaner.
4
Open the screw cap on the bottom of
the tank.
2
5 3
The clean water tank holds the water and cleaning
solution.
IMPORTANT: Always turn the cleaner off and
disconnect from the electrical outlet before
filling the clean water tank.
!
IMPORTANT:When filling
the clean water tank, do not
exceed the max fill line.
!
Do not use any high-foaming solutions as
an excessive amount of foam impairs the
functioning of the shampooer.
Do not use boiling water.
Preferably use distilled water to
prevent calcification.
To Next Page
Loading...
