END
SECTION
BAR/BRUSH
ASSEMBLY
Agitator brushes
Disconnect cleaner from electri-
cal outlet before checking
brushes.
When brushes are worn and
bristles do not touch the edge of a
card held across the nozzle, they
should be replaced. Always re-
place both brushes at the same
time to maintain cleaning effec-
tiveness.
To replace brushes
Disconnect cleaner from electri-
cal outlet,
Remove bottom plate, belt and
agitator following directions pre-
viously given.
1. Hold agitator as shown. Turn
end plates in opposite directions
until one end plate comes off.
2. Pull or pry out end sections as
shown in illustration.
Note: Pulley end should be re-
moved by pulling straight out.
3. Note position of bar/brush as-
semblies to insure correct re-
placement.
Remove bar/brush assemblies by
pulling them from agitator slots.
Use pliers if necessary.
The word "BAR" is stamped
near the slots on the agitator.
Match the bar side of the bar/
brush assembly with the label on
the agitator shell. Slide the new
assemblies into the slots, while
twisting the assemblies in a
counterclockwise motion. Push
in as far as possible, tapping the
outer end lightly if necessary. Be
sure brushes and bars are aligned
for full length of agitator.
20
To Next Page
Loading...
Need help?
General
