Hoover F5912900 User Manual

5
1-14
1-10
1-11
Press cord into cord clip on back of
hose holder. Pull cord tight.
Storing hose
Stretch hose out and identify ends.
F. Nozzle connector end of hose H. Solution tube
G. Trigger I. Converter end of hose
Note: You may find it helpful when storing the hose to refer to the information on the
back of the deep cleaner and on the converter end of the hose.
Start with converter end of hose (I). Fit
converter over tab near tool holder (j).
Press converter firmly to snap in place.
Press solution tube (H) into clip next to
converter as shown.
Wrap hose around hook on upper
handle (K). Press hose into clips on
upper hose holder (L).
H
I
I
J
K
L
H
L
G
F
1-12 1-13
Wrap hose around lower tool holder and
continue until nozzle connector is near
upper hose holder. Clip hose in place.
Continued ➔
How to reattach tool
cover
The tool cover is designed with a break-
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
slots on sides of tool storage area.
Push cover down to secure in place.
1-15
1-16
Stair/upholstery nozzle
To store stair/upholstery nozzle, open
tool door, place nozzle in bracket and fit
it securely into position. To remove,
reverse this procedure.
Upfront tool storage

Hoover F5912900 Specifications

General

AC input voltage	120 V
Cord length	7.3 m
Product color	Black
Removable water tank	Yes
Machine type	Walk-behind
Operating current	12 A
Dirty water tank capacity	3.8 L

Weight and Dimensions

Weight	9100 g