Why Hoover FloorMate PowerBrush 300 won’t run or has low suction?
If your Hoover Vacuum Cleaner won’t run or has low suction, ensure it's firmly plugged in and check the fuse or breaker. Empty the recovery tank, as the automatic shut-off may be engaged if it's full. Also, verify that the filter and filter lid are correctly positioned, the tanks are locked in place, the filter is clean, and the nozzle is properly replaced and locked.
What to do if my Hoover Vacuum Cleaner won’t pick up dirty solution?
If your Hoover Vacuum Cleaner won’t pick up dirty solution or pushes a line of dry debris, ensure the mode selector is set to WET SCRUB and that the recovery tank is correctly installed and not full. Also, check that the filter and filter lid are properly positioned. If dry debris is the issue, switch to DRY VAC mode or tip the nozzle off the floor by pushing down on the handle to pick up large debris.
How to stop water puddling behind my Hoover FloorMate PowerBrush 300?
If your Hoover Vacuum Cleaner is puddling water, try using the recommended detergents to reduce excess foaming. Also, make sure the solution tank is installed properly and that the recovery tank is empty.
What to do if cleaning solution won’t dispense from Hoover Vacuum Cleaner?
If the cleaning solution won’t dispense from your Hoover Vacuum Cleaner, first ensure that the solution tank is locked in position. If it still doesn't dispense, refill the solution tank, as it may be empty.
Why is agitator not rotating on my Hoover Vacuum Cleaner?
If the agitator on your Hoover Vacuum Cleaner won’t rotate, check that the mode selector is set to WET SCRUB. If that doesn't solve the issue, try resetting the circuit breaker. You should also clean the agitator to remove any debris, such as threads or strings, that may be obstructing it.
General| Brand | Hoover |
|---|---|
| Model | FloorMate PowerBrush 300 |
| Category | Vacuum Cleaner |
| Language | English |
Step-by-step guide on filling the solution tank with water and cleaner.
Outlines the steps for dry vacuuming and wet scrubbing.
To Next Page