Hoover FloorMate, SpinScrub Floor Mate Spin Scrub Hard Floor Cleaner User Manual (English)

Questions and Answers:

S
Sylvia RosalesJul 30, 2025
How to fix Hoover Vacuum Cleaner with low suction?
- B
  Brittany GentryJul 30, 2025
  If your Hoover Vacuum Cleaner won't run or has low suction, try these steps: * Ensure the cleaner is firmly plugged in. * Check the fuse or breaker. * Empty the recovery tank in case it's full and the automatic shut-off is engaged. * Make sure the filter and filter lid are correctly positioned. * Confirm the tanks are locked in place. * Inspect and clean the filter if it's dirty. * Ensure the nozzle is properly replaced and locked.
K
kelseygomezAug 7, 2025
What to do if Hoover FloorMate, SpinScrub Floor Mate Spin Scrub Hard Floor Cleaner Vacuum Cleaner won’t pick up dirty solution?
- R
  Robert BryantAug 7, 2025
  If your Hoover Vacuum Cleaner is not picking up the dirty solution and is pushing a line of dry debris, here are a few things you can try: * Ensure the Mode selector dial is set for WET PICKUP. * Make sure the recovery tank is correctly installed. * Empty the recovery tank. * Ensure the filter and filter lid are properly positioned. * Check the Model selector dial to ensure it is set for DRY VAC. * Tip the nozzle off the floor by pushing down on the handle to pick up debris that is too large to clear the squeegee.
M
Meredith BlackburnAug 14, 2025
Why is my Hoover FloorMate, SpinScrub Floor Mate Spin Scrub Hard Floor Cleaner leaving water puddles?
- D
  darellanoAug 14, 2025
  If you notice water puddling behind your Hoover Vacuum Cleaner, here's what you should do: * Use the recommended detergents to reduce excess foaming. * Make sure the solution tank is installed properly. * Empty the recovery tank.
D
Dylan WardAug 21, 2025
What to do if Hoover FloorMate, SpinScrub Floor Mate Spin Scrub Hard Floor Cleaner cleaning solution won’t dispense?
- C
  cjohnsonAug 21, 2025
  If the cleaning solution isn't dispensing from your Hoover Vacuum Cleaner, ensure the solution tank is locked in position and refill the solution tank if it is empty.