l The appliance has a special filter that
traps larger residues that could block the
draining system, such as buttons or coins
(depending on the model, consider
version A or B).
We recommend checking and cleaning
the filter 5 or 6 times a year.
l Disconnect the machine from the power
supply.
l Ensure all the water has been emptied
from the drum.
l Before unscrewing the filter, we
recommend you place an absorbent cloth
under it to keep the floor dry. A small
amount of water will come out of the filter
as you remove it - this is normal.
l Turn the filter counter-clockwise to the
limit stop.
l Remove and clean the filter; when
finished, replace it turning it clockwise.
The filter handle will be locked when it is
not possible to turn any further and the
handle is horizontal. Smearing a small
amount of liquid soap on the filter seal will
help refitting.
l Repeat the previous steps in reverse
order to reassemble all parts.
l If the appliance is kept in a non-heated
room for long periods of time, all water
residues must be completely removed
from the pipes.
l Disconnect the machine from the power
supply socket.
l Detach the tube from the drainage system
and clip on the rear of the machine and
lower it, fully draining water into a bowl.
l Secure the drain tube with the drainage
system and clip on the rear of the
machine when finished.
l Keep the door glass and gasket clean.
FOR MODELS WITH AUTOMATIC
LIQUID DETERGENT AND SOFTENER
DOSING SYSTEM:
should you need to tilt or move the
machine, remove the detergent drawer
before proceeding, keeping it
horizontal so as to avoid any leakage.
To Next Page
Loading...
Need help?
General
