Using the Power Management
Using power management you can set the total power to 2.5kW/ 3.0kW/ 4.5kW/
6.5kW and 7.4kW. The default total power setting is the maximum power level.
Setting the total power level to fit your requirement
1. Make sure the cooktop is turned off.
Note: you can only set power management when the cooktop is turned off.
2. Touch the button “Pause function” and hold for 5 seconds. You can
hear the buzzer beeps one time.
3. After you hear the
beep,
touch “+” and “-” button at the same time and hold for
3 second, the timer indicator will show flashing previous total power level, e.g.
‘2.5’. Touch and hold ” +” and ”-” for 1 second
again
to switch to
other
power level,
for example 3.0. When the power that you want is flashing, touch the button
“Pause function” and hold for 5 seconds. The buzzer will beep 10 times. It means
you have finished the setting.
Note:
1. After step 2, you must touch the “+” and “-” within 3 seconds after you hear
the beep. Otherwise you will need to start again from step 2.
2. Once finish setting, wait till the end of 10 beeps. Do not touch any button during
this period. Otherwise the setting will be invalid.
Power management Rules
If total power exceeds the limitation of 2.5kw, 3.0kw, 4.5kw, 5.5kw 6.5kw or
7.4kw (depending on which level you’ve set), you are not able to increase power
stage of any zone. If you increase it by touching ‘+’, the cooktop will beep 3
times and indicator will show a flashing ‘Pn’. Thus you need to decrease power
stage of other zones before increasing the power of objective zone.
To Next Page
Loading...
Need help?
General
