Hoover Power Scrub Elite User Guide

9
Remove both tanks
and tilt the carpet
washer so it is lying on
its back.
Hook the tank release
catch over the front
of the tank and push
downwards to lock the
catch in place.
Lift the nozzle release
clip to unlock the
nozzle.
Hold the front of the
nozzle and push down
to release the nozzle
away from the washer.
Once released, lift to
remove.
Rinse the nozzle under
water (40°C max) to
remove dirt and debris.
To re-fit, slide the dirty
water tank onto the
carpet washer, making
sure the tabs on the
tank line up with the
back of the washer.
To replace the nozzle, hook the tabs on the
nozzle with the front of the carpet washer
and slide the nozzle into place.
Push the nozzle
release clip to lock
the nozzle.
Lift and hook the latch
on the tank onto the lid
and push down to lock
into place.
MAINTENANCE
Removing and cleaning the nozzle
NOTE: To prevent excessive build up of dirt/
debris in the nozzle, always dry vacuum before
using the carpet washer.
CWGDH012_Hoover MEA_Elite Power Scrub_Gladiator_UG_240818.indd 10 24/08/2018 11:47

Hoover Power Scrub Elite Specifications

General

Type	Carpet Washer
Brush System	SpinScrub Brush System
Heated Cleaning	Yes
Cord Length	20 ft
Warranty	2-year limited warranty
Power	10 Amps
Color	Red
Cleaning Modes	Deep Clean, Quick Clean
Included Tools	Upholstery Tool
Tank Capacity	1.25 gallons