Hoover Power Scrub Elite - Pre-Cleaning Preparation

7
OPERATION
Turn the wash/rinse
dial to rinse.
Only water is released
to remove solution
residue.
Press the trigger on the
hose to release water.
Squeeze the trigger
on the forward stroke,
release the trigger on
the backward stroke to
pick up water. Follow
with an additional dry
stroke without the
trigger pressed for a
dryer finish.
Press the trigger on
the hose to release
solution/water.
Squeeze the trigger
on the forward stroke,
release the trigger on
the backward stroke
to pick up solution/
water. Follow with a
slow additional dry
stroke without the
trigger pressed for a
dryer finish.
To remove the tool, lift
and push the tool clip
over the tab at the end
of the hose and pull
to remove.
Using Rinse mode on the hose
CWGDH012_Hoover MEA_Elite Power Scrub_Gladiator_UG_240818.indd 8 24/08/2018 11:47