Hoover Robo-com 2 - Cleaning and Replacing Floor Brushes; Cleaning the Drive Wheels

* Certain Models Only
** May vary according to model
MAINTAINING YOUR ROBO.COM² CLEANER
Cleaning the Floor Brushes
Clean the Floor Brushes regularly to maintain maximum cleaning performance.
1. Turn Robo.com² off and remove from the Charger Base Station.
2. Turn the Robo.com² over.
3. Rotate the Floor Brush assembly carefully and using scissors cut and remove any tangled threads
or hair etc.
4. Use the Multi-purpose Cleaning Brush to remove any excess dust.
Replacing the Floor Brushes
1. Switch the Robo.com² off and turn the Robo.com² over.
2. Pull the Floor Brush Release Latch.
3. Lift the Floor Brushes Retainer.
4. Remove both Floor Brushes.
5. Clean the recess that the Floor Brushes sit.
6. Ret the new Floor Brushes, ensuring they sit correctly.
7. Close the retainer ensuring it locks.
Cleaning the Drive Wheels
1. Switch the Robo.com² off and turn the Robo.com² over.
2. Remove any dirt or hair trapped in the wheels.
3. Clean the wheels with a dry cloth.
4. Check that the wheels can rotate freely.
robo_com2 IM Australia.indd 11 7/19/2012 4:22:24 PM