Hoover Sensory User Manual

3
*Certain Models Only ** Certain models only, nozzles may vary according to model
GB
Removing a Blockage From The System
If the bag check indicator is illuminated or ashing:
1. Check if the bag is full. If so refer to ‘Replacing The Dust Bag’.
2. If it is not full, then;
A. Do the lters need cleaning? If so refer to ‘Cleaning the Filter’.
B. Check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from the Telescopic tube* or exible hose.
WARNING - The bag check indicator will turn red if the cleaner is used when full, if there is a
blockage or if the lters are dirty. If the cleaner is used for a signicant period of time with the
bag check indicator is red, a thermal cut out will switch the cleaner off to prevent overheating.
The bag check indicator turn green once the cleaner has switched off to signal that the
thermal cut out has been activated. If this should happen, switch the cleaner off, unplug and
correct the fault. It will take about 30 minutes for the cut out to automatically reset.
ACCESSORIES AND NOZZLES
All accessories can be tted to the end of the hose handle or the end of the telescopic tube.
Crevice Tool – For corners and hard to reach areas. [22]
Furniture Nozzle – For soft furniture and fabrics. [23]
Hard Floor Nozzle
* – For wooden oors and other delicate oors. [R]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep cleaning
on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs removal. [S]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for allergen
removal. [T]
Grand Turbo Nozzle* - Use the turbo nozzle for deep cleaning on carpets. [U]
IMPORTANT: Do not use the mini turbo nozzle on rugs with long fringes, animal hides and
carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is
rotating.
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the dust bag over-lled? Please refer to ‘Cleaner Maintenance’.
• Is the Filter blocked? Please refer to ‘Cleaning the lter’.
• Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the system’.
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically reset.
•
•
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Ofce.
Quality
BSI ISO 9001
Hoover’s factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as dened by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.

Hoover Sensory Specifications

General

Brand	Hoover
Model	Sensory
Category	Vacuum Cleaner
Language	English