Hoover Studio User Manual

replacing the bag/emptying the permanent bag
replacing the bag (depending on model):
when full (see “ bag check indicator” paragraph) please dispose
of the bag immediately.
open the top-cover and grip the bag holder. lift the bag
holder
vertically out of the cleaner (15).
dispose of the full bag into a bin .
fold and fit new bag into the bag holder (16). replace the
bag
holder into the cleaner.
use only genuine hoover bags.
emptying the permanent bag (depending on model):
when full (see “ bag check indicator” paragraph) please empty
the bag immediately.
open the top-cover and grip the bag holder. lift the bag
holder
vertically out of the cleaner (15).
remove the Permanent Bag from the bag holder.
remove the plastic slide at the end of the bag allowing
dirt
collected to fall into the bin
refit the slide back into its original position.
fit the empty permanent bag into the bag holder (16). replace
the bag holder into the cleaner (1).
check filters for excessive build up of dust. if required, clean
or replace. close the top-cover. see diagrams (2 & 3) to access
the
filters.
to maintain best performance we recommend you wash the
filters and the Permanent bag (depending on model) after 5
full bags. please refer to chapter “filters and permanent bag
maintenance”.
filters and permanent bag maintenance
to maintain best performance we recommend that you rinse the
filters and permanent bag under lukewarm water after 5 full
bags
to access the filters please refer to diagrams 2 & 3
do not scrub the filters and permanent bag and do not
use
detergents
remove excess water with a dry cloth and leave to air dry until
fully dry after completing the washing operations, return
the filters and
permanent bag to their original positions in the cleaner.
removing a blockage from the system
the bag check indicator on your cleaner is activated:
1) check if the dust bag is full. If so refer to chapter
“replacing the bag / emptying the permanent bag”.
2) if not full then:
a) did you wash the filters and permanent bag after 5 full
bags? if not please refer to chapter “filters and
permanent bag maintenance”.
b) check if there is any other blockage in the system.
use a rod or pole to remove any blockage from the
tubes and
flexible hose.
it may also be possible to remove an obstruction in the
flexible hose by lightly squeezing or bending it.
clean the underside of the carpet and hard floor
nozzle
frequently by using the crevice tool.
6

Hoover Studio Specifications

General

Brand	Hoover
Model	Studio
Category	Vacuum Cleaner
Language	English