important safety reminders
this cleaner should only be used for domestic cleaning as
described in these instructions. please ensure that these are
fully understood before operating this appliance. this product
is double insulated and must not be earthed.
important: the wires in the power cord are coloured in
accordance with the following code:
blue - neutral brown - live
13 amp fused plug on uk versions only.
getting started
by following this step-by-step guide your new hoover cleaner
will be ready for use:
remove cleaner and accessories from packaging. Please
dispose of the packaging in a safe and environmentally
conscientious way.
open the top cover (1) ensuring that the bag , pre-motor filter
(2) and exhaust filter (3) are fitted correctly. close the top
cover.
insert the hose end into the top cover, ensuring it clips and
locks into position(4). to release simply press in the two
latches and pull.
fit rigid extension tubes (5), floor nozzle(6), and other
accessories as required for use.
your cleaner is now ready for use. extract the plug and pull
out all of the cord. plug in and switch on.
features
-depending on model, please see cleaner specification
list on/off button (7). once plugged in, press this button to
start the cleaner. press it again to stop the cleaner before
removing the plug after use.
cord rewind button(8).remove the plug from the power supply.
press this button to wind the power cord back into the
cleaner.
bag Check Indicator. (9)
when activated this device warns that the bag requires to be
replaced or emptied. Please refer to chapter, “replacing the
bag / emptying permanent bag”.
if after changing the paper bag or emptying the permanent bag
the bag check indicator is still activated, a blockage has
occurred. please refer to chapter “removing a blockage from
the system”.
fixed power control
(depending on model). adjust the suction
by moving the hose handle valve (10): suction will decrease
when opening the valve. Use low suction for delicate fabrics.
variable power control (11) (depending on model). rotate the
control to increase or decrease suction. use low suction for
delicate fabrics.
carpet and floor nozzle (6). press pedal on the nozzle to
lower the brush head when cleaning hard floors. Press the
pedal again to lift the brush head when cleaning carpets.
dual function tool.
Tool is stored in the back of the
cleaner(12). remove tool and use as:
a) dusting brush for furnishings,bookshelves,frames,keyboards
etc.
b) crevice tool [detach the dusting brush] for corners and
hard to reach areas .
tube parking and atorage (13 & 14). the tubes can be parked at
the rear of the cleaner or stored into the storage slot
underneath of the cleaner.
5
To Next Page
Loading...
Need help?
General
