Hoover Vortex Pro 5231 - Assembly; Installing and Removing the Battery; Assembling the Charger

7.
WARNING! Ensure that the charging base is disconnected from the Mains power
before assembly.
WARNING! Always switch off the cleaner before fitting or removing accessories.
Assembly
1. Insert the battery into the handvac, as shown, ensuring that it clicks
into place.
2. To remove the battery, press the Battery Release button and gently
remove the battery.
1. Place the powerhead onto a flat floor, and insert the Extension Tube
as shown, ensuring it clicks into place.
2. Place the handvac into the main body and push until it clicks into
place.
Warnings
Installing and Removing the Battery
Assembling the Charger
WARNING! Ensure that the charging base is disconnected
from the Mains power before assembly.
1. To assemble the charger insert the top section of the charger into
the charger base ensuring it clicks into place. Plug the power plug
into the mains power supply.