Hoover WindTunnel T1 Series - Hose; Powered Hand Tool

11
4.18
4.16
4.16 Turn tool so bottom faces up. Rotate the
latches (A) on either side of tool.
4.17 Remove bottom plate (B).
4.18 Remove any debris and/ or hair from brushroll.
Replace bottom plate by aligning tabs along front
edge of tool. Rotate latches back into locked position.
A
POWERED HAND TOOL: How to Clean
4.17
B
HOSE: How to Clean
4.15
A
CAUTION
! !
To reduce the risk of injury from moving parts, unplug vacuum before servicing.
4.15 To remove Hose for tool use, press the Hose Release Button (A) and pull
Hose end out.
Clear away debris or obstructions from Hose. Do not use sharp objects to clean
out hose as they can cause damage. To lock back into place, push Hose into
Hose Tube until you hear a click.
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.