Need help?Do you have a question about the horiba SF-1U and is the answer not in the manual?
General| Measurement Principle | Fluorescence |
|---|---|
| Excitation Light Source | Xenon lamp |
| Type | Fluorometer |
| Bandwidth | 5 nm |
| Detector | Photomultiplier tube |
Examples of symbols and their meanings used in safety warnings.
Critical warnings for safe operation and hazard prevention.
Details specific cautions and required actions to avoid hazards.
Shows the location and content of warning labels on the equipment.
Lists directives and standards the equipment conforms to.
Guidelines for proper disposal of electrical and electronic equipment.
Details the need for exhaust connections for flammable gases.
General and specific precautions for handling high-pressure gas cylinders.
Outlines the warranty period, scope, and exclusions.
Prohibits unauthorized copying of manual contents.
Describes the Film Flow Meter and its measurement capabilities.
Explains how the device measures flow rate using a soap film.
Lists items to check upon unpacking the equipment.
Provides detailed specs for SF-1U/SF-2U and VP units.
Lists applicable gases and atmospheric pressure ranges.
Describes display features and automatic measurement functions.
Identifies major external parts and the control panel layout.
Provides detailed descriptions of each numbered part and their functions.
Guidelines for selecting an appropriate location for accurate measurement.
Instructions for connecting the AC adapter and power supply.
Steps for attaching and securing the measuring unit.
Procedure for filling the unit with filming liquid and important notes.
How to connect inlet and outlet gas tubes, including safety warnings.
How to set the calibration temperature for accurate readings.
Procedures for turning on the equipment and initial display.
How to wet the measuring tube for proper operation.
Procedures for setting atmospheric pressure.
Details on normal and automatic measurement procedures.
Steps for setting up and running automatic measurements.
Explains the formula used for flow rate correction.
How to adjust alarm waiting times for A1/A2 alarms.
Tasks for routine daily upkeep of the equipment.
Instructions for replenishing, replacing, and cleaning filming liquid.
Step-by-step guide for cleaning the measuring tube.
Schedule for recommended periodic checks and parts replacement.
Diagnostic steps when the equipment does not turn on.
Identifies causes and solutions for A1 alarms related to the start detector.
Identifies causes and solutions for A2 alarms related to the stop detector.
Addresses issues related to low detector light levels.
Troubleshoots problems related to low voltage conditions.
Explains how to resolve cases where multiple films are created.
Steps to take if the internal clock stops counting.
Details hardware specs, connection, and baud rate settings for PC communication.
Describes how the equipment responds to computer commands.
Lists commands sent from the computer to the SF unit.
Describes the data returned by the SF unit to the computer.
Details printer connection, RS-232C specs, and baud rate settings.
Procedures for initiating printing and recommended printer model.
Shows the format of data printed for normal and automatic measurements.
To Next Page