To Next PageTo Next Page
Need help?Do you have a question about the Hörmann RotaMatic series and is the answer not in the manual?
General| Brand | Hörmann |
|---|---|
| Model | RotaMatic series |
| Category | Gate Opener |
| Language | English |
Explains warning symbols and their meaning for danger levels.
Defines key terms like hold-open phase and automatic timed closing.
Specifies the exclusive purpose and limitations for gate operation.
Highlights specialist requirements for all gate system handling.
Covers critical safety steps before and during gate system operation.
Details essential checks and preparations before installing the operator.
Provides guidance on physically attaching the gate operator unit.
Explains how to mount the operator's control unit.
Details setup for single-leaf gate configurations using limit switches.
Describes the physical adjustment of the CLOSE end-stop position.
Outlines the procedure for programming the gate's closed position.
Details setup for single-leaf gates using mechanical stops or electric locks.
Outlines programming the closed position using mechanical stops.
Outlines programming the open position using mechanical stops.
Instructions for wiring the gate operators for outward opening.
Guidance on integrating mechanical end stops for gate travel.
Procedure for teaching the gate the forces required for movement.
How to adjust the maximum force to prevent trapping.
Information about the wireless remote control transmitter.
Details on the built-in radio receiver for remote operation.
Process for pairing remote buttons with the radio module.
Instructions for connecting an external radio receiver.
Describes the standard functional modes of the gate operator.
Explains how the gate reacts to safety triggers during opening.
Procedure to restore the control unit to default factory settings.
Configures the system for single or double-leaf gate operation.
Sets leaf offset for double-leaf gates to prevent collisions.
Selects leaf for offset learning or size of offset.
Controls system mode for normal use or configuration.
Configures the primary safety device for the OPEN direction.
Configures the secondary safety device for the CLOSE direction.
Enables SE2 for through-traffic detection in the CLOSE direction.
Sets automatic closing, pre-warning time, and option relay behavior.
Adjusts the duration the gate remains open before automatic closing.
Defines system response to impulses during the hold-open period.
Sets the maximum distance for safety reversal actions.
Configures points where slow-speed operation begins.
Sets overall slow speed for all gate movements.
