4
Positioning Your Comb and Cutter
Before you start, ensure the comb screws and tension knob
are slack.
Hold the machine so that you are looking at its underside and
so you can clearly see both comb screws.
Place your comb in the
machine so that the sharp side
faces the forks and adjust the
comb until the heel is level
with the back edge of the comb
screws.
DO NOT position the heel of
the comb to the back of the
comb bed.
Tighten the comb screws nger tight, holding the comb in
place. Not too tight, you may need to adjust this further.
LONGHORN
®
LONGHORN
®
COMB AND CUTTER SET UP
To Next Page
Loading...