horsch Maestro 12 SV - User Manual

Questions and Answers

J
Joshua MartinAug 11, 2025
Why is the hydraulic oil overheated in my horsch Maestro 12 SV Farm Equipment?
- R
  raydeborahAug 12, 2025
  The hydraulic oil may be overheating due to excessive power, a contaminated oil filter, a soiled protective fan grid, a dirty oil cooler, or excessive PTO-shaft speed. To resolve this, reduce power and check the oil level. Also, check the pressure on the fan, change the oil and oil filter, clean the protective fan grid, clean the radiator fins, and avoid unnecessary cooling power by reducing the drive speed.
J
John MartinezAug 19, 2025
How to fix bearing damage on the fan of my horsch Maestro 12 SV Farm Equipment?
- L
  lericksonAug 19, 2025
  Bearing damage on the fan can be caused by normal wear, excessive power, or an imbalance in the impeller wheel. You can replace the bearing. Ensure you never run the fan without connected pneumatic hoses. Replace the impeller wheel or clean it from contamination.
N
Nancy CarterAug 27, 2025
Why is the PTO-shaft pump bearing worn out on my Horsch Farm Equipment?
- J
  Jared VazquezAug 27, 2025
  The PTO-shaft pump bearing might be worn out because the pump is distorted and not sufficiently fastened on the tractor. Replace the bearings, and mount the pump tightly but without distortion.
N
Natalie GravesSep 3, 2025
Why is the radial seal in the motor of my Horsch Farm Equipment leaking?
- M
  Mr. Dakota MartinezSep 3, 2025
  A leaking radial seal in the motor could be due to return pressure being too high. Check the return flow pressure.