Why is there mud/dirt building up on the idlers/mid-rollers of my horsch Maestro SW 3215?
Mud or dirt buildup on the idlers or mid-rollers is caused by operation in muddy, wet, or sticky soil types. Clean the mud and dirt regularly to prevent track damage.
What to do if I notice uneven tread wear on my horsch Maestro SW 3215?
If you observe uneven tread wear, it may be due to a high amount of roading. Try swapping the tracks from side to side.
What to do if the temperature of the idler or roller axle hub is high in my horsch Maestro SW 3215?
A high temperature in the idler or roller axle hub can be caused by bearing failure or a lack of lubricant. Replace the damaged bearing or check the oil level in the reservoir.
What to do if I hear noise from the idler or roller axle hub of my horsch Tractor Accessories?
Noise from the idler or roller axle hub is likely due to bearing failure. Replace the damaged bearing.
What to do if splits/opening appear on the side or top of tread of horsch Maestro SW 3215 Tractor Accessories?
Splits or openings on the side or top of the tread can be caused by a high amount of roading or overheating of the tread. Try swapping the tracks from side to side, and replace the tracks if necessary.
What to do if I see chunking on guide lug sides of horsch Tractor Accessories?
Chunking on the guide lug sides can occur if the track is not aligned properly, due to improper break-in, or side slope operation. * Align the track. * Operate in dry dusty conditions.
What to do if there is breakaway of track guide lugs in horsch Maestro SW 3215 Tractor Accessories?
If there is breakaway of track guide lugs due to debris or material ingestion into the track system, clean the material off of the drive wheel.
What to do if system dog tracking or problems with track alignment occur in horsch Maestro SW 3215?
System dog tracking or problems with track alignment can occur if the alignment adjustment is incorrect or the undercarriages parallelism is out of tolerance. Adjust alignment per procedures.
The following warnings and safety instructions apply to all sections in these operating instructions.
The machine must only be put into operation after receiving instructions by employees of the authorized dealer or a HORSCH employee.
Maestro Machine model 1630 2420 2T 2420 3T Fold Front Fold Front Fold...
Hydraulic movements can lead to severe accidents and injuries!
Any changes to settings made to the row unit assembly... The metering unit is the main part of each row unit...
Maestro Meter Disc & Initial Settings – 15’’ Row Spacing Maestro Meter Disc & Initial Settings – 20-22’’ Row Spacing...
Check the settings on the metering unit before filling... Inspection in the field Besides the settings in the metering unit...
The sensor located in the seed tube is used for monitoring... Once the seed exits the seed tube it is immediately pushed...
During planting the gauge wheels must rest against the opening disc blades... The closing wheels close the seed trench and press the soil...
Troubleshooting Track System Problem Possible cause Solution...
Troubleshooting Maestro Problem Possible cause Solution... Bolt Tightening Torques – Metric Bolts Bolt tightening Torques - Metric bolts (Ft. Lbs)...
General| Brand | horsch |
|---|---|
| Model | Maestro SW 3215 |
| Category | Tractor Accessories |
| Language | English |
To Next Page