Hoss FERTILIZER INJECTOR - Tank Assembly & Parts List; Included Parts; Sold Separately; Cap Tube Fittings: Insert & Release

• (1) Brass Hose Bib Connector
#3060-CG
• (2) Tubing Valves
#TVLV
• Back flow Preventer
SOLD SEPARATELY
• (1) Flo-Disc Set
#K-INSKFD
1 EACH RED, BLACK, & WHITE DISC
• (5 Ft.) Clear 1/4” Tubing #CT5
• (5 Ft.) Black 1/4” Tubing #BT5
WATER IN
BLUE
FERTILIZER
OUT
GREEN
TANK CAP
#CAP-MBT
GREEN
CONNECTOR
#PCG
BLUE
CONNECTOR
#PCB
CAP
FITTING
#APF
DIP TUBES
#DT-SET
TANK ONLY
#TNK-10PVC
AGITATION
FITTING
#AGT
SCREEN
FITTING
#PUF
CAP
ORING
#LOR
INCLUDED PARTS
The Injection System uses push connect
fiings to connect the clear and black
1/4” tubing to the cap.
TO INSERT TUBING INTO CAP
STEP   Insert the end of the tubing into
the appropriate side (Clear to Green/Out
and Black to Blue/In) by pressing into the
hole/Collet. Press gently until the tubing stops.
STEP   Gently tug the tubing to ensure it is securely locked
into place.
TO REMOVE TUBING FROM CAP
STEP   Shut o pressure to the system.
STEP  - Apply gentle pressure to the Green or Blue Collet
with your fingers.
STEP   While holding pressure, gently pull the tubing away
from the fiing to release.
NOTE: Make sure to direct the fiing away from your face and
body. A small amount of residual pressure may be in the tank
and cause a momentary release of fluid.
/” TUBING
/” TUBING
/” TUBING
/” TUBING
PULL TUBING
PRESS TUBING
PRESS COLLET
COLLET
HOLD PRESSURE
TOP VIEW
SIDE VIEW
NEED HELP? CONTACT US! WWW.HOSSTOOLS.COM • 1-888-672-5536 • CUSTSERV@HOSSTOOLS.COM
HOURS: MONDAY-FRIDAY FROM 8:00AM - 5:00 PM EST.
TANK ASSEMBLY & PARTS LIST
FOR ADDITIONAL PARTS OR REPLACEMENT PARTS, VISIT
hosstools.com/product-category/replacement-parts/
The Back flow Preventer uses a
vacuum-breaking system to prevent
polluted water from entering your
water source via back-siphoning.
CAP TUBE FITTINGS: INSERT & RELEASE