The HOST Back Bar Chiller is a commercial refrigeration appliance designed for use in professional settings, specifically for chilling beverages. It is available in various models, including HOST1210SH, HOST1211DH, HOST1212DS, HOST1213TH, HOST1214TS, HOST1215DS, HOST1216SH, HOST1217DH, HOST1218TS, and HOST1219TH. These models differ in door configuration (single hinged, double hinged, double sliding, triple hinged, triple sliding) and dimensions (900mm or 850mm height).

Function Description:

The primary function of the HOST Back Bar Chiller is to maintain a consistent cool temperature for beverages stored within its cabinet. It operates with an automatic defrost system to prevent ice buildup and ensure efficient cooling. The appliance features a control panel for setting and monitoring the internal temperature, and it includes a cooling light to indicate when the unit is actively chilling. Some models come with sliding doors, which can be removed for cleaning or maintenance.

Important Technical Specifications:

The models vary in voltage, power, current, temperature range, capacity, refrigerant type, dimensions (H x W x D), weight, and maximum load per shelf.

Voltage: All models operate on 230V 50Hz.
Power: Ranges from 180W to 300W.
Current: Ranges from 1.2A to 1.76A.
Temperature Range: All models maintain a temperature range of 2°C to 10°C.
Capacity (Litres): Varies significantly by model, from 138 litres (HOST1210SH) to 330 litres (HOST1214TS).
Refrigerant: All models use R600a.
Dimensions (H x W x D):
- 900 x 600 x 520 mm (HOST1210SH)
- 900 x 900 x 520 mm (HOST1211DH, HOST1212DS)
- 900 x 1350 x 520 mm (HOST1213TH, HOST1214TS)
- 850 x 600 x 520 mm (HOST1216SH)
- 850 x 900 x 520 mm (HOST1217DH, HOST1215DS)
- 850 x 1350 x 520 mm (HOST1218TS, HOST1219TH)
Weight: Ranges from 48kg to 80kg.
Max. load of each shelf: All models support a maximum load of 25kg per shelf.
Optimal Storage Temperature for food storage: 4°C.
Optimal ambient temperature and humidity: This appliance is intended to operate in climates where the maximum temperature and humidity are 30°C and 60% respectively.
Impact of temperature settings on food waste: This appliance shall be operated in its designated operating range to reduce food waste from spoilage.
Electrical Wiring: The appliance is supplied with a 3-pin BS1363 plug and lead, requiring connection to a suitable mains socket. Wiring is standard: Live (brown) to L, Neutral (blue) to N, Earth (green/yellow) to E. The appliance must be earthed.
Compliance: The product complies with WEEE regulations for proper disposal and various UKCA regulatory standards and specifications, including those related to machinery safety, electromagnetic compatibility, hazardous substances, and ecodesign.

Usage Features:

Installation: The chiller should be positioned on a flat, stable surface, away from direct sunlight or damp areas. A minimum clearance of 2.5cm is recommended between the unit and walls/objects, and 20cm on top, to optimize performance and longevity. It should never be located next to a heat source. If the unit has been moved or stored in a non-upright position, it should stand upright for approximately 12 hours before operation.
Operation:
- Turning On: Close the door, connect to mains power, and turn the light switches On [I] or Off [O] as desired.
- Setting Temperature: Press the SET button, use the up/down arrows to select the desired temperature, and press SET again to store. The cooling light illuminates when the appliance is actively chilling.
- Manual Defrost: While the unit features automatic defrost cycles every 6 hours (lasting 20 minutes), a manual defrost can be initiated by pressing and holding the up arrow and SET button for 6 seconds. This action resets the automatic defrost timer. The defrost light illuminates during defrost periods.
Shelving: Slide-out shelves can be inserted at desired levels, with smaller shelves placed on the appliance floor. Screw feet allow for leveling.
Door Removal (Sliding Doors Only): For cleaning or lamp replacement, sliding doors can be removed by lifting them into the upper runner, then pulling the bottom out and down. To replace, slot into the upper runner, then push the bottom in and down into the bottom runner. Note that an automatic door-closing system means doors are attached by a cord, which should not be broken or removed.

Maintenance Features:

Cleaning:
- Always switch off and disconnect from the power supply before cleaning.
- Clean the interior as often as possible using soapy water, then dry thoroughly.
- Do not use abrasive cleaning agents, as they can leave harmful residues.
- Wipe dry after cleaning.
- Condensation may form with frequent door opening or in humid conditions; ensure it drains properly or is wiped dry.
Condenser Cleaning: Periodically clean the condenser (located at the back of the appliance) using a soft brush or vacuum cleaner to extend the appliance's life. Care must be taken not to damage the fins.
Safety Instructions:
- Installation and repairs should be carried out by a service agent/qualified technician.
- Do not remove components or service panels.
- Comply with local and national standards (e.g., Health and Safety at Work Legislation, BS EN Codes of Practice, Fire Precautions, IEE Wiring Regulations, Building Regulations).
- Do not immerse in water or use steam/jet washers.
- Do not cover the appliance during operation.
- Do not store food in the appliance.
- Always carry, store, and handle the appliance in a vertical position, never tilting more than 45° from vertical.
- Not suitable for outdoor use.
- Keep packaging away from children and dispose of it according to local regulations.
- If the power cord is damaged, it must be replaced by a qualified technician.
- This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience/knowledge, unless supervised or instructed.
- Do not store explosive substances (e.g., aerosol cans with flammable propellant).
- Keep all ventilation openings clear of obstruction; the unit should not be boxed in without adequate ventilation.
- Do not use mechanical devices or other means to accelerate defrosting, other than those recommended by the manufacturer.
- Do not damage the refrigerant circuit.
- Do not use electrical appliances inside food storage compartments.
- HOST recommends connecting the product to a circuit protected by an appropriate RCD (Residual Current Device).
- HOST recommends periodic testing (at least annually) by a Competent Person, including visual inspection, polarity test, earth continuity, insulation continuity, and functional testing.

Service:

In case of a fault, users are directed to the Service section of the HOST website. The manufacturer provides information on minimum periods for spare parts availability, including door hinges, knobs, dials, buttons, door gaskets, peripheral trays, baskets, and racks. These parts are available to both end users and professional users for a minimum of eight years after the last unit of the model is placed on the market. A broader selection of parts is available to professional users. The model number is located on the interior right-hand wall (and on the rear) of the appliance.

Host HOST1210SH - Page 12

Table of Contents