Host HOST1210SH - Troubleshooting

5
3. Place the door to the side of the appliance.
4. Repeat for the remaining doors.
5. To replace the doors, slot them into the upper runner and then push the bottom of the door in and
down to slot it in to the bottom runner.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault Probable Cause Solution
The appliance is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug or lead is damaged Replace plug or lead
Fuse in the plug has blown Replace the fuse
Mains power supply fault Check mains power supply
The appliance turns
on, but the temperature
is too high/low
Condenser blocked with dust Clean Condenser
Doors are not shut properly Check doors are shut and seals are not
damaged
Appliance is located near a heat
source or air flow to the condenser
is being interrupted
Move the appliance to a more suitable
location
Ambient temperature is too high Increase ventilation or move appliance to a
cooler position
Insufficient airflow to the fans Remove any blockages to the fans
Appliance is overloaded Reduce the amount stored in the appliance
The appliance is
unusually loud
The appliance is touching a
neighbouring object
Check installation position and change if
necessary
The appliance has not been
installed in a level or stable
position
Check installation position and change if
necessary
Service
Should your appliance have a fault, please visit the Service section of the HOST website.
HOST1210SH to HOST1219TH_EN_A5_v1_20220816.indb 5HOST1210SH to HOST1219TH_EN_A5_v1_20220816.indb 5 2022/8/16 16:032022/8/16 16:03