Host HOST1210SH - Installation

3
• HOST recommend that this product is connected to a circuit
protected by an appropriate RCD (Residual Current Device).
• HOST recommend that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection, Polarity
Test, Earth Continuity, Insulation Continuity and Functional
Testing.
Caution: Risk of Fire
• Do not store explosive substances such as aerosol cans with
a flammable propellant in this appliance.
Warning: Keep all ventilation openings clear of obstruction.
Unit should not be boxed in without adequate ventilation.
•
Warning:
Do not use mechanical devices or other means
to accelerate the defrosting process, other than those
recommended by the manufacturer.
•
Warning:
Do not damage the refrigerant circuit.
•
Warning:
Do not use electrical appliances inside the food
storage compartments of the appliance.
Installation
Note:
Not for use in vans or trailers, food trucks or similar vehicles.
If the unit has not been stored or moved in an upright position, let it stand upright for
approximately 12 hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the appliance in direct sunlight or damp areas.
3. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between
the unit and walls and other objects, with a minimum 20cm clearance on the top.
NEVER LOCATE
NEXT TO A HEAT SOURCE.
4. Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the floor
of the appliance.
5. If necessary, adjust the screw feet of the appliance to make it level.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy
water then dry well.
HOST1210SH to HOST1219TH_EN_A5_v1_20220816.indb 3HOST1210SH to HOST1219TH_EN_A5_v1_20220816.indb 3 2022/8/16 16:032022/8/16 16:03