HOTA F6 - Page 16

12
F6 4-Channel DC Smart Charger
Discharging
Discharging
LiPo-6S(3.60V) 36% 00:00:40
CH1
-5 mAh
22.85V
-0.3A -13W
3.787V
3.789V
1
4
3.792V
3.787V
2
5
3.788V
3.703V
3
6
00:00:00
CH2
Standby
Operation and Setup
Working parameters Display
Discharging Status : Simple Operation
1.Connect power supply to the charger, wait for the system to complete its self-checking. Con
nect the battery to the charger in the standby interface;
2. After selecting the corresponding channel, short press the speed shuttle key to pop upthe
"Task Settings” menu, set the task to "Discharge" ; adjust the task parameters andshort
press the speed shuttle key to start the task;
Scroll the speed shuttle key during operation can switch the display information in the lower half of the screen which are
cell voltage and operating data ; the cell voltage can only be displayed in the mode of balance charging;
3. When the discharge task is executing, short press the speed shuttle key can pop up the
"Adjust Task” menu to adjust the discharge current ; long press the CH key can stop
the current task;
4. Enjoy.
Operation
Time
Capacity
charged
Task Status
Output
Current
Total Battery
Voltage
Output
Power
Operation
Time
Cell Voltage
Current
channel
Current
channel
Battery parameters and
Percentage of completion