HOTA F6 - Page 17

External Discharging
Pb-12S(1.90V) 00:00:45
CH1
-111 mAh
26.79V
-9.1A -245W
00:00:00
CH2
0 pcs
36 C
2.99 mWh
26.79V
Standby
External Discharging
13
F6 4-Channel DC Smart Charger
Operation and Setup
Working parameters Display
External Discharging status : Simple Operation
1. Connect the battery, which is going to discharge ,to the input ends( DC port) of the
charger, and wait for the system to complete its self—checking, then in the standby
interface, connect the high power resistance load to the charger's output ends ;
2. After selecting the corresponding channel, short press the speed shuttle key to pop up
the "Task Settings” menu, set the task to "External Discharge” ; adjust the task parameters and
short press the speed shuttle key to start the task;
3. When the External discharge task is executing, short press the speed shuttle key can pop up the
“Adjust Task" menu to adjust the external discharge current ; long press the CH key can stop the
current task;
4. Enjoy.
Operation
Time
Capacity
charged
Task Status
Output
Current
Total Battery
Voltage
Output
Power
Operation
Time
Cell Voltage
Current
channel
Current
channel
Battery parameters and
Percentage of completion