HOTA F6 - Page 18

14
F6 4-Channel DC Smart Charger
Storage Charging
Storage Charging
LiPo-6S(3.80V) 00:00:19
CH1
0 mAh
22.70V
0.0A 0W
3.806V
3.806V
1
4
3.806V
3.810V
2
5
3.806V
3.811V
3
6
00:00:00
CH2
Standby
Operation and Setup
Working parameters Display
Storage Charging Status : Simple Operation
1. Connect power supply to the charger, wait for the system to complete its self-checking. Con
nect the battery to the charger in the standby interface;
2. After selecting the corresponding channel, short press the speed shuttle key to pop up the
“Task Settings" menu, set the task to “Storage” ; adjust the task parameters, and short
press the speed shuttle key to start the task;
Scroll the speed shuttle key during operation can switch the display information in the lower half of the screen, which are
cell voltage and the operating data ; the cell voltage only be displayed in the mode of balance charging.
3. When the storage task is executing, short press the speed shuttle key can pop up the"Adjust
Task" menu to adjust the storage current ; long press the CH key can stop the current task;
4. Enjoy.
Operation
Time
Capacity
charged
Task Status
Output
Current
Total Battery
Voltage
Output
Power
Operation
Time
Cell Voltage
Current
channel
Current
channel
Battery parameters and
Percentage of completion