HOTA F6+ - 4 Charger Settings 1

18
F6+ 4-Channel DC Smart Charger
Adjust Safety Timer, Max Capacity, End Current and other parameters
Adjust Language, Regenerative Discharge,Input Power, Volume and other
parameters
Used for PWM measurement, RF airplane control servo manual and
automatic test,PPM output
Used for channel 1 data calibration
Used for channel 2 data calibration
Used for channel 3 data calibration
Used for channel 4 data calibration
Start self—checking of the charger
Restore all parameters to factory settings(User calibration data clean up)
Display system information, serial number
Exit charger settings
Task Parameters
System Parameters
Tools
CH1 Calibrations
CH2 Calibrations
CH3 Calibrations
CH4 Calibrations
System Self-checking
Factory Settings
System Info
Back
Charger Settings
Task Parameters
System Parameters
Tools
CH2 Calibrations
CH1 Calibrations
System Self-Checking
Factory Settings
System Info
Back
CH3 Calibrations
CH4 Calibrations
Charger Settings
Operation and Setup
In the alternate interface, long press the speed shuttle key to bring up the "charger
settings" menu, the menu items are as follows：