What to do if Hotpoint Ariston Dishwasher won't start?
First, ensure the water supply tap is turned on and the dishwasher door is closed properly. Check if the appliance is plugged in correctly or try another electricity socket. If these steps don't work, try switching the appliance off and on using the ON/OFF button, waiting approximately one minute before switching it back on, then reset the wash cycle.
What to do if Hotpoint Ariston LFF 8S113 won't drain water?
Several reasons could cause this issue. The wash cycle might not be finished yet. Inspect the water drain hose to ensure it is not bent. Also, check if the drain duct is clogged, or if the filter is clogged with food residues. Finally, verify the height of the drain hose.
Why is my Hotpoint Ariston LFF 8S113 not cleaning dishes properly?
Several factors can cause this. Ensure the crockery is arranged properly and the sprayer arms can rotate freely without being hindered by the dishes. The selected wash cycle may be too gentle, or there might be too much foam due to incorrect detergent dosage or unsuitable detergent. Also, check that the rinse aid compartment lid is closed correctly, the filter isn't dirty or clogged, and the refined salt level is adequate. Verify the height of the dishes is compatible with the rack adjustment and that the holes in the sprayer arms aren't clogged.
Why are dishes covered in white film in my Hotpoint Ariston Dishwasher?
This could be due to a lack of refined salt or an unsuitable water hardness adjustment; try increasing the relevant values. Make sure the salt and rinse-aid dispenser cap is closed properly. It may also be that the rinse aid has been used up or the dosage is too low.
How to fix excessive noise from Hotpoint Ariston LFF 8S113 Dishwasher?
The noise could be caused by dishes rattling against each other or the sprayer arms. Ensure the dishes are placed properly and the sprayer arms can rotate freely. Too much foam, caused by incorrect detergent dosage or unsuitable detergent, can also cause noise. Avoid pre-washing dishes by hand.
Why Hotpoint Ariston LFF 8S113 won't load water and has flashing lights?
This issue can occur if there is no water in the mains supply or the tap is shut off. Inspect the water inlet hose for any bends. Also, the filters or the drain duct might be clogged and need cleaning. After checking and cleaning these, switch the dishwasher on and off and start a new wash cycle.
What to do if Hotpoint Ariston LFF 8S113 Dishwasher door won’t close?
Ensure that the racks are fully inserted. Also, make sure the lock was released. Push the door firmly until you hear a 'clacking' noise.
Why are my dishes streaked after using Hotpoint Ariston LFF 8S113?
The rinse aid dosage might be too high.
Why is crockery not drying properly in my Hotpoint Ariston LFF 8S113?
A wash cycle without a drying programme may have been selected. Also, the rinse aid may have been used up, or the rinse aid dispenser setting may not be suitable. Note that crockery made from non-stick material or plastic may retain water drops, which is normal.
General safety guidelines for operating the appliance.
Guidance on connecting water supply, inlet, and outlet hoses.
Instructions for safely connecting the appliance to the electrical supply.
Explanation of buttons, indicators, and display functions.
Guidelines for correctly measuring and using detergent for optimal results.
Step-by-step instructions for initiating a wash cycle.
Guidance on choosing cycles and determining detergent amounts.
General| Type | Freestanding |
|---|---|
| Appliance placement | Freestanding |
| Capacity | 13 place settings |
| Energy Efficiency Class | A+ |
| Number of Wash Programs | 8 |
| Height | 85 cm |
| Width | 60 cm |
| Depth | 60 cm |
| Control panel colour | Black |
| Delayed Start Timer | Yes |
| Delay Start (max) | 24 hours |
| Half load option | Yes |
| Wash Programs | Eco, Intensive, Normal, Soak |
| Drying system | Condenser |
To Next Page