To Next PageTo Next PageHow to fix a Hotpoint Ariston LFT 228 that does not start?
If your Hotpoint Ariston Dishwasher doesn't start, check the following: * Ensure the plug is correctly inserted into the electrical socket and that there is power in your home. * Make sure the dishwasher door is properly shut. * Verify that a delayed start has not been programmed.
Why are the dishes not clean in my Hotpoint Ariston LFT 228 Dishwasher?
If your Hotpoint Ariston Dishwasher isn't cleaning dishes properly, consider these potential issues: * The racks might be overloaded, or the crockery might not be arranged well. * The sprayer arms might be obstructed. * The selected wash cycle might be too gentle. * Too much foam might be present due to incorrect detergent dosage or unsuitable detergent. * The rinse aid compartment lid might not be closed correctly. * The filter might be dirty or blocked. * The refined salt level might be low.
Why is my Hotpoint Ariston Dishwasher making so much noise?
If your Hotpoint Ariston Dishwasher is making excessive noise, consider these possible causes: * Dishes might be rattling against each other or the sprayer arms. * Too much foam might have been produced because the detergent wasn't measured correctly or isn't suitable for dishwashers.
Why does my Hotpoint Ariston Dishwasher leave a white film on dishes?
If there's a white film or limescale on your dishes and glasses after using your Hotpoint Ariston Dishwasher, consider these potential reasons: * The refined salt level might be low, or the dosage setting isn't right for your water hardness. * The salt dispenser lid might not be closed properly. * The rinse aid might be used up, or the dosage is too low. * The crockery might be made from non-stick material.
What to do when Hotpoint Ariston Dishwasher doesn't take water and shows tap shut-off alarm?
If your Hotpoint Ariston Dishwasher isn't taking in water and the tap shut-off alarm is sounding, check the following: * Ensure there is water in the mains supply. * Check if the water inlet hose is bent. Turn on the tap; the appliance will start after a few minutes. If the appliance lock has been activated because no action was taken when the beeps sounded, switch off the machine using the ON/OFF button, turn on the tap, and switch the machine back on after 20 seconds by pressing the same button. Re-programme the machine and restart the wash cycle.
Why are my dishes not drying in my Hotpoint Ariston Dishwasher?
If your dishes aren't drying properly in your Hotpoint Ariston Dishwasher, consider the following: * A wash cycle without a drying program might have been selected. * The rinse aid might be used up, or the dosage is too low. * The rinse aid dispenser setting might not be high enough.
Why does my Hotpoint Ariston Dishwasher leave streaks on glasses?
If your dishes and glasses have streaks or a bluish tinge after using your Hotpoint Ariston Dishwasher, it might be because the rinse aid dosage is too high.
How to fix Hotpoint Ariston LFT 228 filters and trap blocked alarm?
To address the Filters and trap blocked alarm on your Hotpoint Ariston Dishwasher: Switch off the appliance by pressing the ON/OFF button, remove and clean the filters, inspect and clean the trap, then switch the machine back on by pressing the same button again. Re-programme the machine and restart the wash cycle.
What to do if my Hotpoint Ariston LFT 228 Dishwasher doesn't drain water?
If your Hotpoint Ariston Dishwasher isn't draining water, consider these possible causes: * The dishwasher cycle might not be finished yet. * The water outlet hose might be bent. * The drain duct might be blocked. * The filter might be clogged with food residues.
What to do for water inlet hose alarm on Hotpoint Ariston Dishwasher?
To address a Water inlet hose alarm on your Hotpoint Ariston Dishwasher: Switch off the appliance by pressing the ON/OFF button. Shut off the water tap to eliminate the risk of flooding, remove the plug from the electrical socket and contact Assistance.
General| Appliance placement | Freestanding |
|---|---|
| Product size | Full size (60 cm) |
| Control panel colour | White |
| Noise level | 49 dB |
| Washing class | A |
| Drying class | A |
| Energy consumption per cycle | 1.05 kWh |
| Energy Efficiency Class | A |
| Delay Start | Yes |
| Child Lock | No |
| Water consumption per cycle | 11 L |
| Depth | 60 cm |
| Height | 85 cm |
Guidance on how to properly position and level the dishwasher on the floor.
Instructions for safely connecting the dishwasher to water and electricity.
Ensuring the electrical connection meets safety and regulatory standards.
Explanation of the buttons, indicators, and display functions.
Methods to adjust the upper rack for optimal loading space.
Step-by-step guide to initiating a wash cycle.
Essential safety guidelines for the use and operation of the appliance.
Steps to take before contacting technical support.
Solutions for power, startup, and water intake problems.
Resolving issues with water not draining from the dishwasher.
Fixing film, limescale, streaks, or unclean dishes.
Solutions for improper drying of crockery.
